350545 1–1
Section 1 Introduction
GENERAL DESCRIPTION
The water-saver is an add-on system that incorporates a water ejector with
a pump and a water reservoir to recirculate the water that creates the
vacuum necessary for part of the sterilization cycle. The water-saver can
typically save 70% of the total water used during a cycle.
Compatible sterilizer models are listed in Table 1–1.
• In this manual, "MP-129 Water-Saver" refers to MP-129A, B, C, and D.
• The MP-129A can be installed on the 400/500 Series sterilizers, but the
MP129F is preferred because it does not require a pressure switch.
Table 1–1. Water-Saver Models
Water-Saver Model Sterilizer Model
MP-129A
MP-129B
MP-129C
MP-129D
M/C 3500 and 100 Series (see Note)
M/C 3600 and 200 Series
M/C 4233 (42")
M/C 4233 (76")
MP-129F 400/500, 700 and 800 Series
NOTES
To Next Page
Loading...
