Start-up Configuring Applause Media System
Page 4-6 MDE-4699L Applause™ Media System Installation, Service, and Parts Manual · June 2017
4 Select the dispenser CRIND type(s) at this site and then click Continue.
Notes: 1) The Control Center Settings information can be found at Gilbar
co extranet at
http://www.gilbarco.com/ interactive/login.cfm. The Port Number must always be set
to 80.
2) The Passkey field can be left blank for
a new installation as the site server will
generate a new random passkey. The passkey is used to authenticate the site server
with the Control Center during syncing. If the site server software is reinstalled, you
must enter the correct passkey for the site. Passkey is available on the Gilbarco
extranet in the Applause Sites link (see Figure 4-7 on page 4-8). Note the passkey
value. It will be necessary for later use
(for example, if the site server software is
upgraded or reinstalled).
Figure 4-5: Control Center Settings Screen
Note: It is not necessary to enter the Passkey number, when you start-up for
the first time.
To Next Page
Loading...
Need help?
General