Introduction Recommended High-Level Installation Process Scenarios
Page 1-8 MDE-5369E FlexPay™ IV (with Omnia) Programming and Service Manual · April 2020
Recommended High-Level Installation Process Scenarios
The following sections outline high-level processes for different installation scenarios.
New FlexPay IV CRIND High-Level Installation
The following installation steps are in the recommended order and are applicable for a new
FlexPay IV CRIND installation with Omnia:
1 Utilize pre-installation, installation, and post-installation checklists in “Installation
Checklists” on page 3-1.
2 Install the Applause Media Server, if required. Refer to MDE-4699 Applause Media System
Installation, Service, and Parts Manual.
3 Install the dispenser hardware in one dispenser. For more information on the Retrofit Kit or
Upgrade Kit Installation Instructions, see
“Related Documents” on page 1-10.
4 Configure Omnia through Omnia Setup Wizard (includes Insite360 registration). For more
information, see
“Configuring FlexPay IV” on page 4-1.
5 Test and verify operation of one dispenser including Applause Media System, before
configuring additional dispensers.
Note: Do not proceed with the entire forecourt installation if a problem is detected with the
first dispenser.
6 Repeat steps 3 and 4 to proceed with the next dispenser until the site is completed. To save
time in step 4, refer to “Omnia Setup with Wizard - Import Configuration” on page 5-18 to use
the configuration that you created for the first dispenser.
Note: You may add additional dispensers based on the number of dispensers the customer will
allow to be down at a time.
Retrofit Installation Process from FlexPay II
The following installation steps are in the recommended order and are applicable for a retrofit
FlexPay IV CRIND with Omnia installation in an environment where FlexPay II was
installed:
1 Pre-installation checklist. For more information, see “Installation Checklists” on page 3-1.
2 Install FlexPay IV door; install Omnia in one dispenser. For more information on the Retrofit
Kit or Upgrade Kit Installation Instructions, see
“Related Documents” on page 1-10.
3 Install Applause Media Server, if required. Refer to, MDE-4699 Applause Media System
Installation, Service, and Parts Manual.
4 Update UPM software to 42.11.XX or later, if not already at that software level, and configure.
To Next Page
Loading...
Need help?
General
