Omnia PCB Media Configuration for Applause Media System
Page 5-24 MDE-5369E FlexPay™ IV (with Omnia) Programming and Service Manual · April 2020
Configuring Insite360 Encore
To view, modify, and test current Insite360 Configuration Settings, proceed as follows:
1 Select the “General Settings” tab on the left side of the web page. Confirm the “Select Pump
connection type” setting and click Save. PCN Version 04.xx.xx supports RTP-serial, which is
required for remote management of door sensors.
2 Select the “Insite360 Settings” tab on the left side of the web page.
Figure 5-34: Insite 360 Configuration Settings
3 Check Internet connection using the CLOUD Utility.
Figure 5-35: Checking Internet Connection
To Next Page
Loading...
Need help?
General
