Name: GILBARCO VEEDER-ROOT FlexPay IV Insite360 Encore
Brand: GILBARCO VEEDER-ROOT
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Troubleshooting PIP3 Connections

Page 6-4 MDE-5369E FlexPay™ IV (with Omnia) Programming and Service Manual · April 2020

PIP3 Connections

Ensure that the loopback jumper is in place on the B side of the PIP3.

Figure 6-3: PIP3 Loopback Connector

Pins 6 and 7

(shorted)

Figure 6-4: Loopback Connector Location on PIP3 (B Side Only)

PIP3

Loopback

Connector

Installation

Location

Note: This PIP3 Loopback Connector must be installed before dispenser power is

applied.

Pin 1

Pins Connection Status

1-5 Open

6 and 7 Shorted

Note: If a M14339A002 is not available, you can use 0.1-inch jumper.

8 Open

Questions and Answers:

Need help?

Do you have a question about the GILBARCO VEEDER-ROOT FlexPay IV Insite360 Encore and is the answer not in the manual?

GILBARCO VEEDER-ROOT FlexPay IV Insite360 Encore Specifications

General