MDE-5369E FlexPay™ IV (with Omnia) Programming and Service Manual · April 2020 Page 1-1
Purpose Introduction
1 – Introduction
Purpose
This manual provides instructions for the following:
• Set or modify the IP configuration for FlexPay
™
IV CRIND
®
• Configure the Omnia board
• Set up the Applause
™
Media System connectivity
• Register with Insite360
™
Encore
®
Cloud for remote management
This manual also includes common troubleshooting and verification steps to ensure network
connectivity of dispensers.
Overview
The Omnia Printed Circuit Board (PCB) inside the dispenser serves the following purposes:
• Creating a Local Area Network (LAN) within the dispenser, so that the Internet Protocol
(IP) addresses of the Ethernet
®
connected devices inside the dispenser are no longer
exposed on the site Wide Area Network (WAN).
• Functioning as a router and firewall, only exposing the A and B side CRIND devices to
the forecourt.
• The configuration of the forecourt IP address, media, and Insite360 is performed on a
single web page.
• Running two-wire proxy applications that allow connection from the Point of Sale (POS)
to the CRIND and the pump.
• Allows the pump and CRIND serial interfaces to run through the Omnia board instead of
the Universal Payment Module (UPM). The UPM and Omnia manage the pump and
CRIND through TCP.
• FlexPay IV GSoMs are removed and the media client runs on the Omnia.
• Secure Systems on Module (SSoM) is removed and the Omnia manages the remote
connection to the Insite360 server.
This manual provides service information and guidance on the following:
• Networking configuration of FlexPay IV CRIND terminals equipped with Omnia
• Software configuration of Omnia (network settings/Cloud/media)
• Registration of the dispensers to the Insite360 Cloud (must include a valid customer
contract)
To Next Page
Loading...
Need help?
General
