Omnia Setup with Wizard - New Configuration Omnia PCB
MDE-5369E FlexPay™ IV (with Omnia) Programming and Service Manual · April 2020 Page 5-7
Omnia Setup with Wizard - New Configuration
After logging into the Omnia configuration page, proceed as follows:
1 Click Setup Wizard.
Figure 5-11: Setup Wizard
2 The Configuration Wizard page opens. Click New configuration.
Figure 5-12: Configuration Wizard
Note: After the Omnia PCB is configured on the first unit, you have the option to save the
completed configuration for the site and import that configuration on the next unit.
You can export the configuration from the Tools tab on the left side of the programming
screen.
To Next Page
Loading...
Need help?
General
