Name: GILBARCO VEEDER-ROOT FlexPay IV Insite360 Encore
Brand: GILBARCO VEEDER-ROOT
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Omnia Setup with Wizard - Export Config Omnia PCB

MDE-5369E FlexPay™ IV (with Omnia) Programming and Service Manual · April 2020 Page 5-17

Figure 5-24: Reboot Status

Omnia Setup with Wizard - Export Config

Click Export Config to export and re-use the current configuration of the device on another

dispenser of the same site.

Note: When importing a saved configuration, you mus

t set the Pump IDs and the External IP

Addresses because these will be different for each dispenser.

Figure 5-25: Export Configuration

Questions and Answers:

Need help?

Do you have a question about the GILBARCO VEEDER-ROOT FlexPay IV Insite360 Encore and is the answer not in the manual?

GILBARCO VEEDER-ROOT FlexPay IV Insite360 Encore Specifications

General