Omnia PCB Omnia Maintenance Through USB
Page 5-56 MDE-5369E FlexPay™ IV (with Omnia) Programming and Service Manual · April 2020
Checking Package Installation Report on the USB Drive
To view the package installation report, proceed as follows:
1 Insert the USB drive used to install packages on Omnia in your PC/Laptop.
2 Go to gvr\omnia\logs. Open the folder with the name of the Omnia PPN, as shown in the
following figure:
Figure 5-81: Folder Named with Omnia PPN
3 Open the file named “OmniaSession-YYYYMMDDhhmmss.txt”. The file includes
information about all of the operations performed during Maintenance session (until the USB
drive was is attached to the Omnia board). Check that file to validate the maintenance
operations performed.
Retrieving Logs
To retrieve logs, proceed as follows:
1 Open OmniaOp.json file with a Text Editor (for example, Notepad++).
2 Specify the log units that you want to view, as shown in the following figure:
Figure 5-82: Log Retrieval
3 Save the file.
To Next Page
Loading...
Need help?
General
