Omnia PCB Omnia Maintenance Through USB
Page 5-60 MDE-5369E FlexPay™ IV (with Omnia) Programming and Service Manual · April 2020
Retrieving the Omnia Configuration and Checking Files on the USB Report
To perform the operation, proceed as follows:
1 Insert the USB drive used to install packages on Omnia in your PC/Laptop.
2 Go to gvr\omnia\cfgs. Open the folder with the name of the Omnia PPN, as shown in the
following figure:
3 Open the file named “OmniaConfig.txt”. This text file contains all of the information about the
Omnia configuration.
4 Open the file “OmniaSession-YYYYMMDDhhmmss.txt”. This text file includes information
about operations performed during the Maintenance session (until the USB drive was attached
to the Omnia).
5 Check the files to validate the configuration and maintenance operations performed.
To Next Page
Loading...
Need help?
General
