Omnia PCB Omnia Web Pages
Page 5-30 MDE-5369E FlexPay™ IV (with Omnia) Programming and Service Manual · April 2020
Completing the Programming
To complete the programming, proceed as follows:
1 Exit the Omnia Configurator.
2 Re-establish two-wire communication to the POS.
Note: Depending on the POS, a purge may be required. Then, download the POS application.
3 Test the unit operation and open the fueling positions for use.
Omnia Web Pages
Omnia Home Page
Omnia home page provides a quick overview of the software installed, hardware version
revision, date and time, Up time, Multiple Access Control (MAC) address, and PPN.
1 After successful login, the Omnia home page opens (see Figure 5-47).
Figure 5-47: Home Page
To Next Page
Loading...
Need help?
General
