Omnia PCB Omnia Maintenance Through USB
Page 5-54 MDE-5369E FlexPay™ IV (with Omnia) Programming and Service Manual · April 2020
OmniaOp.JSON File Syntax
The OmniaOp.json script is a JSON syntax file that defines a sequence of maintenance
operations. If the JSON syntax is not correct, the execution is not started (comments not
included). The file must be populated with at least one of the operations as shown in the
following figure:
Figure 5-78: Maintenance Operations
Note: The actions or parameters that are not supported are ignored.
The following figure shows th
e OmniaOp.json file content to perform all the operations:
Figure 5-79: OmniaOp.json File Content
To Next Page
Loading...
Need help?
General
