MDE-5369E FlexPay™ IV (with Omnia) Programming and Service Manual · April 2020 Page 1-9
Recommended High-Level Installation Process Scenarios Introduction
5 Configure Omnia from the Omnia Web page (includes Insite360 Registration). For more
information, see
“Configuring FlexPay IV” on page 4-1.
6 Test and verify operation of one dispenser including Applause Media System, before
configuring additional dispensers.
Note: Do not proceed with the entire forecourt installation if a problem is detected with the
first dispenser.
7 Repeat for each dispenser until the site is completed.
Retrofit Installation Process from FlexPay IV
The following installation steps are in the recommended order and are applicable for an
installation of Omnia in an environment in which FlexPay IV is already installed.
1 Pre-installation checklist.
2 Install Omnia in one dispenser. For more information, refer to “Related Documents”
on page 1-10.
3 Install Applause Media Server, if required.
4 Update UPM software to 42.11.XX or later, if not already at that software level, and configure
CRIND. Refer to FlexPay IV CRIND Configuration.
5 Configure Omnia from the Omnia Web page (includes Insite360 registration).
6 Test and verify operation of one dispenser including Applause Media System, before
configuring additional dispensers.
Note: Do not proceed with the entire forecourt installation if a problem is detected with the
first dispenser.
7 Repeat for each dispenser until the site is completed.