GILBARCO VEEDER-ROOT FlexPay IV Insite360 Encore User Manual

Omnia PCB Omnia Setup with Wizard - New Configuration
Page 5-16 MDE-5369E FlexPay™ IV (with Omnia) Programming and Service Manual · April 2020
15 Click Save and exit to complete the Wizard procedure.
Omnia will display a confirmati
on message as shown in Figure 5-21.
Figure 5-21: Confirmation Popup Window
16 Click Yes, save it.
Omnia applies the new co
nfiguration after a duration of 5 seconds.
Figure 5-22: New Configuration
17 After the configuration is saved and applied, reboot the Omnia board from the Tools tab or
warmstart the dispenser.
Figure 5-23: Reboot Prompt

GILBARCO VEEDER-ROOT FlexPay IV Insite360 Encore Specifications

General

Brand	GILBARCO VEEDER-ROOT
Model	FlexPay IV Insite360 Encore
Category	Petrol Station Equipment
Language	English