Omnia Setup with Wizard - New Configuration Omnia PCB
MDE-5369E FlexPay™ IV (with Omnia) Programming and Service Manual · April 2020 Page 5-13
10 If the Cloud (remote management) was selected, the wizard will open the configuration page
as shown in Figure 5-17
Field Configuration Settings
General Configuration
GVR ID GVR ID
Omnia Nickname Site name.
Note: Use the same name for all units.
Incremental logs Ensure that the check box is selected (Do
wnload Enabled)
Download Logs Every (mins) Leave at 30 minutes unless directed to change by Gilbarco.
PUMP Configuration Settings Configuration
Pump Type Select one of two options depending on which pump is connected to
the
dispenser.
•E300
• Encore Pump (This is the default)
Two-Wire Money Mode Select one of two options depending on how the pump is configured
.
• 5 Digits Money Mode (This is the default)
• 6 Digits Money Mode
Money Decimal Position Select one of four options depending on the format sent to the i36
0
servers.
•X.x
• X.xxx
•X
• X.xx (This is the default)
PPU Decimal Position Select one of four options depending on the format sent to the i36
0
servers.
•X.x
• X.xxx (This is the default)
•X
•X.xx
CRIND Configuration Settings Configuration
Barcode Scanner Side A present Enable only if the unit has a scanner on this side.
Printer Side A present Enable only if the unit has a printer on this side.
Barcode Scanner Side B present Enable only if the unit has a scanner on this side.
Printer Side B present Enable only if the unit has a printer on this side.
on page 5-14.
To Next Page
Loading...
Need help?
General
