TERMS AND CONDITIONS
All products and services provided by Orpak Systems Ltd. without exception are subject to the Orpak
Systems Ltd. General Terms and Conditions. Ensure that you read through the General Terms and
Conditions completely prior to performing any procedures detailed in this document.
SAFETY CONSIDERATIONS
Carefully read all warnings and instructions, provided to help you install and maintain the equipment
safely in the highly flammable environment of a gas station.
Disregarding these warnings and instructions could result in serious injury and property loss or damage.
It is your responsibility to install, operate and maintain the equipment according to the instructions in
this manual, and to conform to all applicable codes, regulations and safety measures. Failure to do so
could void all warranties associated with this equipment.
Ensure that the installation is performed by experienced personnel, licensed to perform work in gas
stations and in flammable environments, according to the local regulations and all relevant standards.
Do not touch the OrPAY1000 for more than 10 seconds when the ambient temperature is more than
70⁰C.
WARNING - EXPLOSION HAZARD
Use a separate conduit for intrinsically safe wiring. Do not run any other wires or cables through this
conduit, since it may lead to an explosion hazard.
Use standard test equipment only in the non- hazardous area of the fuel station, and approved test
equipment for the hazardous areas.
Installation and service must comply with all applicable requirements of the National Fire Protection
Association NFPA-30 “Flammable and Combustible Liquids Code”, NFPA-30A “Automotive and Marine
Service Station Code”, NFPA-70 “National Electric Code”, federal, state and local codes and any other
applicable safety codes and regulations.
Do not perform metal work in a hazardous area. Sparks generated by drilling, tapping and other metal
work operations could ignite fuel vapors and flammable liquids, resulting in death, serious personal
injury, property loss and damage to you and other persons.
CAUTION - SHOCK HAZARD
Dangerous AC voltages that could cause death or serious personal injury are used to power the
equipment. Always disconnect power before working on the equipment. The equipment may have more
than one power supply connection point. Disconnect all power before servicing.
WARNING – PASSING VEHICLES
When working in an open area, block off the work area to protect yourself and other persons. Use safety
cones or other signaling devices.
WARNING
Substitutions of components could impair intrinsic safety. Use of unauthorized components or
equipment will void all warranties associated with this equipment.
II OrPAY1000 Installation and Setup Manual
To Next Page
Loading...
Need help?
General
