CAUTION
Do not attempt to make any repair on the printed circuit boards that reside in the equipment, as this will
void all warranties associated with this equipment.
PROPRIETARY NOTICE
The information contained in this guide is confidential and proprietary to Orpak Systems Ltd. No part of
this guide may be disclosed or reproduced in any form without written permission of Orpak Systems
Ltd. The information provided in this document is current as of the date of its publication, and it may be
changed at any time without notice.
DISCLAIMER
This document is provided for reference only and while every effort has been made to ensure
correctness at the time of publication, Orpak Systems Ltd. assumes no responsibility for errors or
omissions.
FCC COMPLIANCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures :
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment to an outlet on a circuit different from that to which the receive is
connected
Consult an authorized dealer or service representative for help
FCC WARNING
Modifications not expressly approved by the manufacturer could void the user authority to operate the
equipment under FCC Rules.
OrPAY1000 Installation and Setup Manual III