GKB 4CH/8CH VFire Server
123
n Type – whether this camera is IP CAM or N/A. If IP CAM, the IP CAM settings
will be settable. Press +/- (Mouse: Left click) to change the type.
n Resolution – the record resolution for the camera. For IP CAM, it can be 1080p,
720p or D1. Press +/- buttons to select the resolution.
n PTZ – Whether it’s a PTZ camera. Press +/- buttons to change the value (N/A
or Yes). The default setting is “N/A” – Not Available, which means that it’s not
a PTZ camera.
n IP CAM Settings.. – used to setup the IP CAM related settings for this camera.
Press ENTER (Mouse: Left click) in Settings.. to call up IP CAM Setup display for
the camera as shown below.
Please select ONVIF for the IP CAM that can support ONVIF profile S, or RTSP for IP
CAM that cannot. For ONVIF, user can click on Discover to discover the IP CAM in
the LAN automatically, and then click on the IP CAM in the list for the URL and
Onvif Port. For RTSP, please enter Main Stream URI and Dual Stream URI
manually. Please also enter the correct Username and Password for the IP CAM.
Please note that camera setup is not supported for RTSP. However, live/network
view, record, and playback are supported, but users need to configure the bit rate
and the frame rate of main/dual stream manually so that the maximum incoming
bandwidth won’t be exceeded.
To Next Page
Loading...