GKB 4CH/8CH VFire Server
42
6.2.2 Motion Setup
In Camera Setup, press ENTER to call
up Motion Setup as shown when the
highlighted option is Motion Settings..
of the camera to setup. The Motion
setup allows the administrator to
define how the system responds to
the detected motion for the camera.
The general operations are as below:
n ▲▼ (Mouse: Left click)
Press these buttons to select the
items.
n Numeric
Press these buttons to select the camera.
n COPY ( )
Press this button to copy the Motion settings, including Detection settings, of
the focus camera to all the following cameras. (EX. focus camera is 1, its
Motion settings will be copied to those of cameras 2-8/4.)
n ESC (Mouse: Right Click)
Press this button to escape from this screen, and return to Camera Setup
display. If the Save dialog is shown, press ENTER to exit and save, ESC
(Mouse: Right Click) to exit without saving.
Following is a brief description for each item and its specific operations:
n Duration – response duration to define at most how long (in seconds) the
Alarm Out relay and the Buzzer will keep being triggered after motion is
detected for this camera. However, the Alarm Out relay and the Buzzer will
be reset immediately once the camera returns to normal. Press +/- buttons
to adjust the value (3 seconds - 60 minutes, discrete, ‘-‘ for ‘Forever’).
n Camera to go – the camera to go to the preset position in next field after
motion is detected for this camera. “Camera to go” camera must be a PTZ
camera.
To Next Page
Loading...