GKB 4CH/8CH VFire Server
41
n Goto Preset – to define the preset position to go to for the “Camera to go”
Camera in last field if video loss is detected for this camera. For more details
about preset locations, please refer to Chapter 7 PTZ Control.
n Pre-record – to define how long before video loss is detected this camera shall
be intensively recorded at Pre-record IPS. Press +/- buttons to adjust the
value (0-10 seconds, discrete). Please note that the actual pre-record time
may be shorter than the value set if the total size of the pre-record pictures
exceeds the pre-record buffer size of the system.
n Alarm Out – to define which Alarm Output will be triggered when video loss of
this camera is detected. Press +/- buttons to select none (N/A) or one of the
Alarm Outputs (NC (1), NO (2)).
n Buzzer – to activate the internal Buzzer or not when video loss of this camera is
detected. Press ENTER or +/- (Mouse: Left click) to check/uncheck this item.
The default setting is “ˇ” - checked.
n Log – to log to event logs or not. Press ENTER or +/- to check/uncheck this
item. The default setting is “ˇ” - checked.
n Screen Message – to display the event message on the screen or not. Press
ENTER or +/- to check/uncheck this item. The default setting is “ˇ” - checked.
n E-mail – to send the event e-mail to remote station or not. The e-mail will be
sent to the predefined receivers at the moment when the event is triggered.
Press ENTER or +/- to check/uncheck this item. The default setting is “–” -
unchecked.
n FTP – to send the recorded event video/audio files to FTP server or not. Press
ENTER or +/- to check/uncheck this item. The default setting is “–” -
unchecked.
To Next Page
Loading...