GKB 4CH - Page 38

GKB 4CH/8CH VFire Server
38
Following is a brief description for each item and its specific operations:
n Title – The title (Max. 16 characters) of this camera. Please follow the Text
Input method described in Section 4.1 to modify this item.
n Video Loss Settings.. – used to setup the action settings when video loss is
detected for this camera. Press ENTER (Mouse: Left click) in Settings.. to call
up Video Loss Setup display for the camera. Please refer to Section 6.2.1 for
the details.
n Motion Detection – whether the motion detection of this camera is enabled or
not. Press ENTER or +/- to check/uncheck this item. The default setting is
“ˇ” - checked.
n Motion Settings.. – used to setup the motion settings, used for Motion
Detection, for this camera. Press ENTER (Mouse: Left click) in Settings.. to call
up Motion Setup display for the camera. Please refer to Section 6.2.2 for the
details.
n Covert – covert or not. If the camera is covert, the video of this camera can
only be seen if the user has logged in as Administrator. Press ENTER or +/-
(Mouse: Left click) to check/uncheck this item. The default setting is “–” -
unchecked.
n Call By Event – whether to switch the monitor to the video of this camera if
certain event occurs for this camera. There are 4 options, including Off,
Motion, Alarm, Both (Motion & Alarm). Press +/- buttons to select one.
n Dwell Time – the dwell time if Call By Event is set to Motion, Alarm, or Both.
Press +/- buttons to adjust the value (3-60 seconds, discrete).
n Audio – the AUDIO IN corresponding to this camera. The audio data for the
selected AUDIO IN will be recorded with the video data for this camera. Press
+/- buttons to select none (N/A) or AUDIO Input (1) or “Yes” for IP-CAM audio.
The default setting is “N/A”.
n Record Quality – the record quality for this camera. Press +/- buttons to select
the value (1-9, with 1 the lowest (rough) quality, 9 the highest (fine) quality).
n Event Record IPS – the IPS (Images Per Second) for this camera if certain event
(Motion, Alarm) occurs for this camera. This camera will be recorded at this
rate for Post-record time since the event occurs. (Please refer to the following
sections for Post-record time.) Press +/- buttons to select the value (0 – 25