GKB 4CH/8CH VFire Server
55
If the Save dialog is shown, press ENTER to exit and save, ESC (Mouse: Right
Click) to exit without saving.
Following is a brief description for each item and its specific operations:
n Size (GB) – the total HDD storage in GB (Giga-Byte) for Alarm Record and
Normal Record respectively. This item is just for information. Please refer to
Section 6.6.1 for more detailed information and setup of each individual HDD.
Please note that if the total alarm record size is zero, the alarm video/audio will
be recorded in normal record partition. Please note that if the total normal
record size is zero, the normal video/audio will be recorded in alarm record
partition.
n Auto Overwrite – automatic overwrite of the recorded video/audio from HDD#1
when the Alarm/Normal Record disk drive capacity reaches the end of the last
HDD. If Auto Overwrite is disabled and the Alarm/Normal Record disk drive
capacity reaches the end, the system will not overwrite the recorded
video/audio, and hence not record Alarm/Normal video/audio, until the user
presses the Alarm Reset button. Press ENTER or +/- to check/uncheck this
item. The default setting is “ˇ” - checked.
n HDD Full Action – actions when Alarm/Normal Record disk drive capacity
reaches the end of the last HDD. Press ENTER or +/- to check/uncheck this
item. The default setting is “ˇ” - checked.
n Duration – response duration to define at most how long (in seconds) the
Alarm Out relay and the Buzzer will keep being triggered after the
corresponding partition, Alarm Record or Normal Record, is full. Press +/-
buttons to adjust the value (3 seconds - 60 minutes, discrete, ‘-‘ for ‘Forever’).
n Alarm Out – to define which Alarm Output will be triggered when the
corresponding partition, Alarm Record or Normal Record, is full. Press +/-
buttons to select none (N/A) or one of the Alarm Outputs (NC (1), NO (2)).
n Buzzer – to activate the internal Buzzer or not when the corresponding partition,
Alarm Record or Normal Record, is full. Press ENTER or +/- to check/uncheck
this item. The default setting is “ˇ” - checked.
n Log – to log to event logs or not. Press ENTER or +/- to check/uncheck this
item. The default setting is “ˇ” - checked.
n E-mail – to send the event e-mail to remote station or not. The e-mail will be
sent to the predefined receivers when the event is triggered. Press ENTER or
+/- to check/uncheck this item. The default setting is “–” - unchecked.
To Next Page
Loading...