GKB 4CH/8CH VFire Server
57
with default record size, 100% for Alarm record and 0% for Normal record.
If it has been formatted (and recorded), it will be partitioned according to
the Alarm Record Size (%) and Normal Record Size (%) displayed on the
screen, and the previously recorded contents will all be cleared.
n CALL => Physical Format (Mouse: Left click)
Press this button to physically format the selected HDD. A confirmation dialog
will be shown on the screen, press ENTER to confirm, or ESC to cancel. Please
note that the recording will be always optimized for performance & lifetime no
matter it’s for the first time or for the one hundredth time. The formatting
would take less than 1 minute. We strongly recommend that the user use this
physical format function to format the HDD for the first time.
Note: The HDD will be physically formatted and partitioned with default record
size, 100% for Alarm record and 0% for Normal record. All the previously
recorded contents will be cleared.
n ESC (Mouse: Right Click)
Press this button to escape from this screen, and return to HDD Setup display.
If the Save dialog is shown, press ENTER to exit and save, ESC (Mouse: Right
Click) to exit without saving.
Following is a brief description for each item and its specific operations:
n Size (GB) – the total storage in GB (Giga-Byte) for the HDD if it has been
formatted. This item is just for information.
n Alarm Record(%) – Alarm Record Size (in percentage) for this HDD. Please
follow the Text Input method described in Section 4.1 to change the value.
Please note that if the alarm record percentage for all HDDs is zero, the alarm
video/audio will be recorded in normal record partition. Please note that if
the total normal record size is zero, the normal video/audio will be recorded in
alarm record partition.
n Normal Record(%) – Normal Record Size (in percentage) for this HDD. It
equals to (100% - Alarm Record Size). This item is just for information.
n NAS/Setup – used to setup NAS (Network Attached Storage) related
parameters if NAS is connected to the NVR. Press ENTER (Mouse: Left click) in
Setup to call up NAS Setup display as shown.
To Next Page
Loading...