GKB 4CH - Page 78

GKB 4CH/8CH VFire Server
78
follow the Text Input method described in Section 4.1 to modify this item.
n HTTP Port – the HTTP (web page) port for remote access. The default value is
80. Please note that value 0 means to disable HTTP.
n UPNP Port Forwarding – to use UPnP port forwarding for Control/Data/HTTP
port for internet access if the router supports UPnP. Press +/- buttons to
change the value. If UPnP port forwarding is used, the NVR will try to connect
with UPnP router to set Control/Data/HTTP port after the user exits from this
screen. It may take from a few seconds to a few minutes. If successful, new
Control/Data/HTTP port will be shown with (*) in front of it.
n WAP Picture Quality – the WAP picture quality if WAP access is supported for the
NVR. Press +/- buttons to change the value.
n Video Stream Resolution – network live video stream resolution. Press +/-
buttons to change the value. For V8.07 or above, “Dynamic” is added for
dynamic resolution adjustment based on remote video window resolution and
network bandwidth.
n Video Stream Quality – network live video stream quality. Press +/- buttons to
change the value. Please note that the value cannot be changed due to the
limitation of the main chip.
n DVR/NVR Name – the “DVR/NVR Name” used in the “CMS Server” if CMS Server
(described below) is (to be) connected with the DVR/NVR. Please follow the
Text Input method described in Section 4.1 to modify this item.
n CMS Server URL #1-2 – the URL (Uniform Resource Locators) for the CMS Server
#1 and #2. The DVR/NVR will connect with up to two CMS servers
automatically once it’s running. Please note that with this feature, the NVR
needs not to be a web server, while the CMS server needs to be a web server.
Please follow the Text Input method described in Section 4.1 to modify these
items.
n IP Filter #1-4 – the IP filters #1-4 for remote access. Only those PCs with IP
addresses matching one of the IP filters can access the DVR/NVR remotely.
Please follow the Text Input method described in Section 4.1 to modify these
items.
Note: If the Control Port or Data Port is not available or accessible during remote
access, the system will reset the ports to their default values, i.e. 67/68.