P a g e | 54
GDS3705 User Manual
Version 1.0.1.16
Configures PIN stored in GDS3705, input locally this PIN on the GDS3705
keypad will unlock the door.
This feature needs Private PIN, means every member has a private PIN,
the GDS will record who unlocked the door every time.
Users need to enter the following sequence from the GDS3705 to open
the door [*Virtual Number*Private PIN#].
Note: When local PIN type is set to private card PIN, users can also open
the door by swiping their cards.
Local PIN to Open Door
Schedule
Configure a schedule for the Local PIN to open the door for “Unified PIN”
mode only. Once configured, the door opening ability using local PIN with
turn ON/OFF based on configured schedule. The schedule can ONLY be
edited when “Central Mode” disabled.
Notes: If “Central Mode” enabled, the “Schedule” page cannot be edited.
(a green “Central Model” label will display in top right corner of the UI).
When “Central Mode” enabled, the “Schedule” will be edited in
GDSManager and synchronized by pulling from GDSManager down to
GDS3705 device.
Default setting is “All Day”.
When enabled, remote SIP phones can open the door while in call by
entering the remote PIN code configured (the PIN code is sent via DTMF).
Default settings is disabled.
Enables password entry for guests.
Configures the password that will be used by guests.
Selects the start time when the Guest PIN start to take effect.
Selects the end time when the Guest PIN will stop working.
If checked, GDS3705 will not answer incoming calls automatically, users
can press any key to answer the call.
Default setting in unchecked.
Enable Doorbell Button to
Hang up Call
If checked, Users can hang up an active call when pressing the doorbell
button. Enabled by default.
Disable Keypad (except
the Doorbell Button)
When checked the Keypad will be disabled, only Door Bell button can be
pressed.
Enable On Hook After
Remote Door Opened
When checked calls will be disconnected automatically 5 seconds after
the remote open door event.