UCM630xA Series User Manual
Version 1.0.9.10
The sent email is too large or the email attachment type is prohibited
The sender and the email account are inconsistent, please configure the
sender as your email account correctly.
The email was identified as spam. Please reduce the sending frequency
or try again the next day
Indicates that there is no return code.
If the sending result is "deferred", the general reason is that the mail
service area is configured incorrectly. Please check whether the server
configuration is correct.
If the sending result is "bounced", the general reason is that the
receiving email address domain name is wrong, please check whether
the email recipient is the correct email address. If it is in MTA mode,
please check whether the "domain" is configured to be in the same
domain name as the "recipient".
HA
Dual-system hot standby provides a highly reliable and fault-tolerant solution for enterprises using UCM6300
series/UCM6300A series. Based on two UCM devices of the same product model and software version, one of them
is in the "Active" working state in real time, and the other is in the "Standby" working state. The daily data on the host
server will be synchronized to the standby machine in real time, and the standby machine monitors the running status
of the host at all times. When the host fails, including hardware failures and severe software failures, the standby
machine will immediately take over the business and enter the "Active" working state, and Upgrade to a host to ensure
that the business is not interrupted, and the call will automatically resume.
Before forming a paired HA dual-system hot backup, two UCM devices need to complete their respective network
settings. The network mode can only be switching or routing, and the IP type can only be static.
HA settings
The users can configure the HA under System Settings HA settings page.
To Next Page
Loading...
Need help?
General
