Grandstream Networks UCM6302A User Manual

P a g e | 116
UCM630xA Series User Manual
Version 1.0.9.10
Hardware Fault Switch
If issues are detected with the selected connection interfaces, the backup UCM6510 will
take over services after the master/slave handover. If not checked, UCM will send only
a fault alarm.
HA Status
Once the HA is configured, the user can view its status under system settings  HA  HA Status as shown below
Figure 57: HA Status
HA Log
The user can view the HA log through the system settings  HA  HA log page. The HA log effectively records the
execution results of past full backup actions, as well as the historical records that triggered the active/standby
switchover.
TR-069
To configure TR-069 on Grandstream devices, set following parameters:
Parameter
Description
Enable TR-069
Toggle it on to enable TR-069. It is enabled by default
ACS URL
URL for TR-069 Auto Configuration Servers (ACS), e.g., http://myacs.grandstream.com
TR-069 Username
ACS username for TR-069, must be the same as in the ACS configuration.

Grandstream Networks UCM6302A Specifications

General

Brand	Grandstream Networks
Model	UCM6302A
Category	PBX
Language	English