UCM630xA Series User Manual
Version 1.0.9.10
If enabled, the system will create a room whose room number, by default, will equal
the extension number in PMS module. Note: If this room already exists, the
configuration of the existing room will be overwritten.
Specify which Music On Hold class to suggest to the bridged channel when putting
them on hold.
The maximum duration of call-blocking.
The maximum call duration (in seconds). The default value 0 means no limit.
If disabled, UCM will not invite the extension when it is already in a call and will do
the same work as the user is busy.
Note: the option only works when the caller dials the extension directly.
Batch Add IAX Extensions
Under Web GUIExtension/TrunkExtensions, click on “Add”, then select extension type as IAX Extension
and the add method to be Batch.
Table 54: Batch Add IAX Extension Parameters
Specify the number of extensions to be added. The default setting is 5.
Select how much to increment successive extensions. For example, if the value is 2,
the extensions will be 1000,1002,1004,......
The extension number associated with this particular user/phone.
Assign permission level to the user. The available permissions are “Internal”, “Local”,
“National” and “International” from the lowest level to the highest level. The default
setting is “Internal”.
Note: Users need to have the same level as or higher level than an outbound rule’s
privilege in order to make outbound calls from this rule.
Configure the Caller ID number displayed when dialing calls from this user. Note:
To Next Page
Loading...
Need help?
General
