UCM630xA Series User Manual
Version 1.0.9.10
Monitor privilege control
Add members from “Available Extensions” to “Selected Extensions” so that the
selected extensions can spy on the used extension using feature code.
Seamless transfer privilege control
Allowed to
seamless transfer
Any extensions on the UCM can perform seamless transfer. When using Pickup Incall
feature, only extensions available on the “Selected Extensions” list can perform
seamless transfer to the edited extension.
Configure the number of seconds to ring the user before the call is forwarded to
voicemail (voicemail is enabled) or hang up (voicemail is disabled). If not specified,
the default ring timeout is 60 seconds on the UCM630xA, which can be configured in
the global ring timeout setting under Web GUIPBX SettingsVoice
PromptCustom Prompt: General Preference. The valid range is between 3 seconds
and 600 seconds.
Note: If the end point also has a ring timeout configured, the actual ring timeout used
is the shortest time set by either device.
Enable automatic recording for the calls using this extension. The default setting is
disabled. The recordings can be accessed under Web GUICDRRecording Files.
If set to “yes”, users can skip entering the password when making outbound calls.
If set to “By Time”, users can skip entering the password when making outbound
calls during the selected time condition.
If set to “No”, users will be asked to enter the password when making outbound
calls.
Time Condition for
Skip Trunk Auth
If ‘Skip Trunk Auth’ is set to ‘By Time’, select a time condition during which users can
skip entering password when making outbound calls.
Configure personal password when making outbound calls via trunk.
If enabled, the extension will be added to LDAP Phonebook PBX list.
To Next Page
Loading...
Need help?
General
