UCM630xA Series User Manual
Version 1.0.9.10
can set wakeup
service for other
extensions
Configure the number of seconds to ring the user before the call is forwarded to
voicemail (voicemail is enabled) or hang up (voicemail is disabled). If not specified,
the default ring timeout is 60 seconds on the UCM630xA. The valid range is between
5 seconds and 600 seconds.
Note: If the end point also has a ring timeout configured, the actual ring timeout used
is the shortest time set by either device.
Enable automatic recording for the calls using this extension. The default setting is
disabled. The recordings can be accessed under Web GUICDRRecording Files.
If set to “yes”, users can skip entering the password when making outbound calls.
If set to “By Time”, users can skip entering the password when making outbound
calls during the selected time condition.
If set to “No”, users will be asked to enter the password when making outbound
calls.
Time Condition for
Skip Trunk Auth
If ‘Skip Trunk Auth’ is set to ‘By Time’, select a time condition during which users can
skip entering password when making outbound calls.
Configure personal password when making outbound calls via trunk.
Check to enable Hot-Desking Mode on the extension. Hot-Desking allows to use the
same endpoint device and login using extension/password combination. This feature
is used in scenarios where different users need to use the same endpoint device
during different time of a day for instance. If enabled, SIP Password will accept only
alphabet characters and digits. Auth ID will be changed to the same as Extension.
If enabled, the extension will be added to LDAP Phonebook PBX list.
To Next Page
Loading...
Need help?
General
