GRAPHTEC FC9000-140 - Page 143

FC9000-UM-251-9370 8-53
8 Electrical Adjustment
(6) Press the Right position key to display the following menu.
(7) Press the Down position key until the following menu is displayed.
(8) Press the F2 key to display the following menu.
(9) Press the F2 key to move the pen carriage to the exchange position.
Andthenconrmthegapbetweenthe2ndpenholderandthe2ndpenstation.
The gap must be 1.2 mm.
When this gap is too far or too close, the 2nd pen will not exchange correctly.
Andconrmtheheightbetweenthe2ndpenholderandthe2ndpenstation.
The top of pen holder must be same height.
This gap should be 1.2 mm.
(10) When the gap is not 1.2 mm, press the F3 key to adjust the gap.
Adjust gap using the up or the down position key.
(11) Measure the gap between the 2nd pen holder and the 2nd pen station.