GRAPHTEC LABELROBO LCX603 - Page 121

LCX603-UM-651-9370 3-20
3 Installing the Printer Driver
VectorizeRasterLinesSettings
......................................... ThevectorizesettingscanbesetonlyduringMethod2and3.
Performnelinevectorizing
.............................. Vectorizingisperformedafterthedatahasbeenconverted
tonelines.
Ifthelinestobevectorizedaretoowide,thedriverwillnot
recognizethemasCutlinesandtheywillnotbeoutput.If
youwanttooutputsuchlinesasCutlines,checkthisbox.
Usethisoptionwithapplicationswherenelinescannotbe
output.
LineLength........... Speciestheminimumlengthofthecutlinestobeoutput.
Thedriverignoreslineswhichareshorterthanthislength,
anddoesnotoutputthem.
Thesettingsrangeis0.1mm-5.0mm.
Treatassamelineifgapis
.............................. Speciesthedotgap,whichisacceptableassameline
data.
Dependingontheapplicationused,gapscanoccurinan
outputrasterline,makingitdifculttodeterminewhether
thesegmentsarefromthesamelineorseparatelines.This
optionllsinthedotsandenablesoutputasonecontinuous
line.However,ifthisvalueistoolarge,separatelinesmay
betreatedasonecontinuousline.
Thesettingsrangeisfrom0to20dots.
RestoreDefaults............... Resetsthesettingstotheiroriginalvalues.