GRAPHTEC LABELROBO LCX603 - Page 122

LCX603-UM-651-9370 3-21
3 Installing the Printer Driver
[Options] Tab
Whenyouclickonthe[Options]tab,thefollowingscreenappears.
Resolution........................ Selecttheresolutionfordataoutputfromeither600dpi×600dpior600dpi×
1200dpi.
Typically,pleaseuse600dpi×600dpi.
Whenswitchingresolutionfromthedriversoftware(600×600dpi←→600×
1200dpi),ifthereisdatacurrentlybeingoutput,performtheswitchonceall
datahasbeenoutput.Pleaseusecaution,sincechangingtheresolutionduring
dataoutputconsumesnon-printmedia.
TransferDataType........... SpecifythetypeofdatatobetransferredfromeitherPCXorRAW.
Typically,pleaseusePCX.
Dithering........................... None”,“Coarse”or“Fine”canbeselected.
Typically,use“None”.
RestoreDefaults............... Resetsthesettingstotheiroriginalvalues.
End of setup
Install the application software and perform the printing test.
Explain the operation of the LCX603 to your customer after setup of LCX603.