GRAPHTEC LABELROBO LCX603 - Page 38

LCX603-UM-651-9370 2-30
2 Setup
(11) PresstheFEEDkeyfollowingtheinstructionsfromthecontrolpanelwhenthemediahasbeensetto
themediastocker.
Themediawillbefeduntilthemediacomesoutfromthefeedrollerpart.
Media comes out here
Thefollowingmessagewillbedisplayedifthemediaisnotinstalledtothemediastockercorrectly.
Installthemediatothemediastockercorrectly.
L01: No M e d ia
Set the M e dia i nto
stoc k er.
Then pres s FEE D key.
(12)Whenthefollowingmessageisdisplayed,insertthemediastraightthroughthespacebetweenthe
feedrollerandpressroller(Step1,2),andthensetthepressrollerlever(Step3).
L02: Pass t he m e dia
thro g h pr e s s-r o l ler
and c lose t he l e ver.
Then pres s FEE D key.
Setthemediaexactlystraightalongthepositionscale.
Press roller lever
Step 1
Step 2
Step 3
Positionscale