GRAPHTEC LABELROBO LCX603 - Page 39

LCX603-UM-651-9370 2-31
2 Setup
(13)Passthroughthemediaasshowninstep1ofpicturebelow.Andholdaedgeofmediawithyour
hand.
(14)PresstheFEEDKeyuntiltheenoughmediaisfedtoaroundtheseparatorarmasshowninthe
picturebelow(step2).Themediashouldbepassedthemediafeedroute.
ThefollowingmessagesaredisplayedwhentheFEEDKeyispressed.
L03: P ress F EED k ey
for f eedi n g an d
sett i ng t h e me d i a.
L03: P ress E NTE R key
when nis h e d
sett i ng t h e me d i a.
Step 1
Pull up the media from here.
The media should pass under
the two cross bar here.
Step 2
Feed the media until here.