GRAPHTEC LABELROBO LCX603 - Page 40

LCX603-UM-651-9370 2-32
2 Setup
(15)Installthemediabythefollowingprocedure.
Step1:Passthroughthemediaintothecutterunit.
Step2:Passthroughthemediaintotheseparatorsuppressionunit.
Step3:Passthroughthemediaintothecrosscuttersection.
Step 1
Step 2
Cutter unit
Pull out the media
from here.
Step3
(16)Themediashouldpassthroughrouteshowninthepicturebelow.