GRAPHTEC LABELROBO LCX603 - Page 41

LCX603-UM-651-9370 2-33
2 Setup
(17)Pullthemediafromtheexitofcrosscutterside(Step1),andalignthemediaandthepositionscale
whilethemediaispulling(Step2).
Whileitisstraight,adjusttheexitpinchrollersposition(Step3).
Theexitpinchrollersshouldbepositionedtobothedgesofmedia.
Whileitisstraight,closetheseparatorsuppressionunit(Step4).
Step1
Exit pinch roller
Step 4
Step 3
Step 2
Separator suppression unit
The exit pinch rollers should be
positioned to both edges of media.
Position scale
(18)Closetheseparatorarmwhilepullingthemedia.
Separator arm