GRAPHTEC LABELROBO LCX603 - Page 42

LCX603-UM-651-9370 2-34
2 Setup
(19)Adjustthepinchrollerpositiontottothemediawidth.
Positionthepinchrollers5mminsidefromthemediaedgeasshowninthepicturebelow.
Pinch roller
Position the pinch rollers 5 mm
inside from the media edge.
(20)Closethecamlever.
Cam lever
(21)Thefollowingmessagesaredisplayingduringinstallingthemedia.
PresstheENTERKeyaftermediaisinstalledtotheLCX603.
L03: P ress F EED k ey
for f eedi n g an d
sett i ng t h e me d i a.
L03: P ress E NTE R key
when nis h e d
sett i ng t h e me d i a.
(22)Thefollowingmessageisdisplayed.
PresstheENTERKey,thisisconrmingtheseparatorwasset.
PresstheENTERKey,eveniftheseparatorwasnotset.
L04: C onr m . Wa s the
wind e r bo b b in s e t?
YES: E NTER
Abovemenuwillnotbedisplayedwhentheseparatorbobbinwassettingtotheseparatorholder.
AbovemenuwillnotbedisplayedwhentheseparatorfunctionsettingwassettingtoOFF.