GRAPHTEC LABELROBO LCX603 - Page 43

LCX603-UM-651-9370 2-35
2 Setup
(23)Thefollowingmessageisdisplayed.
PresstheENTERKey,thisisconrmingthelaminatewasset.
PresstheENTERKey,evenifthelaminatewasnotset.
L04: C onr m . Wa s the
lami n ate i n sta l l ?
YES: E NTER
Abovemenuwillnotbedisplayedwhenthelaminatebobbinwassettingtothelaminateholder.
AbovemenuwillnotbedisplayedwhenthelaminatefunctionsettingwassettingtoOFF.
(24)Thefollowingmessageisdisplayed.Don’tpresstheENTERKeyuntilthedancerrollersareinstalled
totheLCX603.
L04: C onr m . Wa s the
danc e r ro l l er s e t?
Init i aliz e wil l
star t . Y ES: E N TER
(25)Installdancerroller1totheLCX603asshowninthepicturebelow.
Insertbothsidesofthedancerrollerintotheslotthatacceptsit.
Installdancerroller1tothesidewiththeredmark.
Dancer roller 1
(Has a red ring mark on both side)
Red mark
Therearetwokindsofdancerrollers,don’tinstallthemtowrongposition.
Dancer roller 1
There are red rings on both sides.
Used in between the press roller and cutter uint.
There is no red ring.
Used in between the cutter unit
and the separator unit.
Dancer roller 2
Red ring