GRAPHTEC LABELROBO LCX603 - Page 53

LCX603-UM-651-9370 2-45
2 Setup
(16)PushtheleverandslowlyandquietlyreturntheribbonstockertotheLCX603afterallribbon
cassettesweresettotheribbonstocker(Step1).
Pushuntilthereisaclickingsound.Pushandfastentheleversothatitissecuredintheslot(Step2),
andclosetheribbonstockerdoor(Step3).
Step 1
Step 3
Step 2
Lever
(17)Locktheribbonstockerdoorasshowninthepicturebelow.
Lock lever
Settingtheinkribbonisnowcomplete
(18)Settheribbonlevertosetposition.
Set the ribbon lever
when printing.
(19)Afternishingsettingtheinkribbons,adjustthedensitysettingtomatchwiththeinkribbonbefore
printing.