GRAPHTEC LABELROBO LCX603 - Page 84

LCX603-UM-651-9370 2-76
2 Setup
How to install the separator bobbin
(1) Takeoutthedancerroller2fromtheLCX603(Step1),andthenopentheseparatorarmasshownin
thepicturebelow(Step2).
Dancer roller 2
Separator arm
Step 2
Step 1
(2) Takeouttheange,theseparatorbobbinshaft,andbobbinfromtheaccessorybox.
(Theseparatorbobbinshafthaslargerwhitegearthanthelaminatebobbinshaft.)
Installthebobbinandtheangetotheseparatorbobbinshaftasshowninthepicturebelow.
(3) Installtheseparatorbobbinshafttotheseparatorunitasshowninthepicturebelow.