GRAPHTEC LABELROBO LCX603 - Page 85

LCX603-UM-651-9370 2-77
2 Setup
(4) Opentheseparatorsuppressionunit(Step1)andpulloutthemediafromtheseparatorunit(Step2).
Cuttheadhesiveareaofthemediaapproximately100mmfromtheposteriorend(Step3).
Peeltheadhesivesectionofthemedia(Step4).
Pullthebackingmediaonlyoutfromthemediaexitarea.
Pulltheadhesivepartofmediaoutfromtheseparatorsuppressionunit(Step6).
Separator suppression unit
Pull the media
out from here
Separator arm
Cut the adhesive section only
at approximately 100 mm from
the posterior end of the media.
Backing
sheet
Step 3
Step 2
Pull the adhesive section
only out from here
Step 4
Detach the sdhesive
section only
Step 6
Step 5
Step 1
Pull the backing media
only out from here.
(5) Puttheadhesivepartofmediatothebobbinwhilepullingthebackingpartofmediaasshowninthe
picturebelow.
Step 2
Put the adhesive part of
media to the bobbin.
Step 1
Pull out the backing
part of media.