GRAPHTEC LABELROBO LCX603 - Page 86

LCX603-UM-651-9370 2-78
2 Setup
(6) Closetheseparatorsuppressionunitwhilepullingthebackingpartofmediaasshowninthepicture
below.Takecareoftheadhesivepartofmediaisnotputtingtothewhiteexitpinchrollers.
Step 1
Pull out the backing
part of media.
Step 2
Close the separator
suppression unit.
Separator suppression unit.
(7) Closetheseparatorarmwhilepullingthebackingpartofmediaasshowninthepicturebelow.
Andthenwindtheseparatorbobbinmanuallytoavoidtheadhesivepartofmediatotouchtothewhite
exitpinchrollers.
Step 1
Pull out the backing
part of media
Step 2
Close the separator arm
Step 3
Wind the separator
bobbin manually.
Separator arm