Page 32 of 49 S1024.mz-32-V2.1-EN
Assigning Digital Switches on RX
You can also assign a digital output switches over the Telemetry
connection directly in the receiver.
To avoid malfunctioning when assigning digital switches, only the affected
receiver may be in operation during their switch assignment.
1. Bind to the desired receiver and, if needed, switch off any other
receivers
2. Switch to the “Setting & Data View” submenu of the telemetry menu.
3. Use the right selection key to switch to the “RX FAIL SAVE” page. 4.
In the “OUTPUT CH” line, if necessary, select the receiver output to
be switched as described under “Function of the cross-shaped
keypad”.
In the figure on the left, this is, for example, the receiver connection
10 of the receiver.
4. Change to the “INPUT CH” line.
5. Tap the middle ENTER key to activate the value field.
The value field is displayed inverted:
6. Select the desired digital switch.
In the picture on the left this is for example “D01”.
7. Tap the middle ENTER key to complete the process.
The value field is not inverted anymore.
8. Eventually use the same procedure with the assignment of other
switches.
To Next Page
Loading...
Need help?
General
