Page 38 of 49 S1024.mz-32-V2.1-EN
Telemetry Cycle
RF Status
Attention
This also changes the assignment in the column "T. sel." of the submenu "RF
Set". After completing the adjustments, it may be necessary to restore the
original assignment!
In those situations where for example two airplane models are about to be
operated at close proximity to another controlled by two separate
transmitters you may choose to reduce or eliminate the telemetry back
channel of one of the models to avoid potential interference. Situations that
may need to be evaluated such as with drones that have a separate
transmitter for control and camera operations or airplanes that tow or carry
other airplanes can be all pickup interference from the telemetry downlink
transmission. Experiment with the proper telemetry period value for your
situation.
Value Description
Always The transmitter reacts normal to the back-
the selected receiver.
4x / 8x The transmitter reacts to the back-
selected receiver with the chosen delay.
OFF The transmitter telemetry functions are switched off.
This display visualizes the quality of the connection between transmitter and
receiver. If there is no connection to a receiver, the sub- menu can be
opened, but the display remains empty. If necessary, switch on your receiver
or switch to the right receiver.
Upper row
Level of channels 1 … 75 coming from the receiver of the 2.4 GHz band in
dBm at the transmitter.
Lower row
Level of channels 1 … 75 coming from the transmitter of the 2.4 GHz band
in dBm at the receiver.
To Next Page
Loading...
Need help?
General
