Page 46 of 49 S1024.mz-32-V2.1-EN
FCC INFORMATION
Graupner/SJ hereby declares that the radio system S1024 mz-32 HoTT
complies with the Directive 2014/53/EU.
The full text of the EU Declaration of Conformity is available at the following
Internet address: www.graupner.com
FCC: SNL-16008200
KC: MSIP-CMM-sjr-16008200
This equipment has been tested and found to comply with the limits for Part
15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that
to which the receiver is connected.
CAUTION
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This product contains a radio transmitter with wireless technology which
has been tested and found to be compliant with the applicable regulations
governing a radio transmitter in the 2.400GHz to 2.4835GHz frequency
range.
Antenna Separation Distance
When operating your Graupner transmitter, please be sure to maintain a
separation distance of at least 20 cm between your body (excluding fingers,
hands, wrists, ankles and feet) and the antenna to meet RF exposure safety
requirements as determined by FCC regulations.
SIMLIFIED DECLARATION OF CONFORMITY
To Next Page
Loading...
Need help?
General
