Page 35 of 49 S1024.mz-32-V2.1-EN
Stick Calibration
If the center position of the self-neutralizing control stick does not
correspond exactly to 0% control travel you will need to calibrate your
control sticks.
This can be best accomplished with a new model.
1. Change to the “Model list” submenu and create a new model. Any
model type will do.
Do not make any further adjustments and do not adjust trims.
2. Bring up the “Servo View” menu by pressing the shortcut key.
3. If all self-control sticks are in their respective neutral/center position
the servo view menu will show all channels at 0.0 as shown in the
left image.
… If the display looks like the one shown, everything is fine, and the
previously saved model memory can be deleted.
… If the display deviates from the desired values, a stick calibration
is required.
Stick Calibration
1. Switch to the System Menu and tap on the Stick Set Menu.
2. Tap on the start button and follow the instructions for stick
calibration. Please note that you also need to calibrate the two lever
controls LV1 and LV2.
3. When successfully completed you will have the option to save or
cancel the operation.
To Next Page
Loading...
Need help?
General
