Page 36 of 49 S1024.mz-32-V2.1-EN
Servo Display
The Servo View monitor can be called upon at any time by pressing the servo
monitor key on the right side of the radio.
The view represents the active positions of any control or switch including
mixers. The default screen shows channel 1 … 16. A swipe from the bottom
to the top will reveal the additional channels.
The default bar chart view shows the channel position between-150% and
+150% and when a control is moved it will show the maximum deflection
set for that channel.
When tapping on the Servo View screen the presented view will show a
numerical representation of the channels in milliseconds. A value of 1500
ms represents 0% which is the controls middle position.
This view also shows the channel names as assigned by the system or as
named by the user.
To Next Page
Loading...
