GSK CNC Equipment Co., Ltd.
8
■ Do not hammer the motor or its shaft to
protect the encoder from being damaged
when removing or assembling belt wheel.
Helically pressing or drawing tools should be
used for removing and assembling.
■ Servo motor cannot support heavy axial,
radial load. It should be employed with
flexible shaft coupling for load.
■ Anti-loose washer should be used to fix the motor
against loosing.
■ Oil and water should be protected from the motor for
that the oil or water from the cable which has been dipped in the oil or water can be
sticked to the motor, so such possibility should be avoided.
Installation notes
To Next Page
Loading...