D. press the F4 (Host Name) button to
manually input. The Name area will be
activated and become red color after setting.
The default first letter is A, and can be changed
to other string by rotating scroll wheel Encoder
(A, B...Z, a, b...z, 1, 2...9, 0, - in clockwise
sequence). Press the F1 (Enter) button to
confirm current string and automatically enter
the next string input. Repeat the process above
until completing a full name.
A. Press the System button to enter the system
interface followed by pressing the F1 (Interface)
button to configure port parameter.
B. Press the F4 (LAN) button to configure
internet port parameter.
C. Press the F2 (Config) button to configure
relevant parameter.
D. Press the F3 (Manual) button to manually
configure.
E. press the F1 (IP Addr) button to manually
input IP address. The set content will be
activated to become red color. Input required
data and confirm by pressing the F1 (Done)
button. Press the F5 (Clear) button to clear and
input again if error occurs.
To Next Page
Loading...
Need help?
General
